BLOG

Proper Sure Seal Application


temp-post-image


ONE: Cut lenses to eye size of crib lenses down to remove tacky edges


TWO: To prepare your new Sure Seal tube for application, rotate the handle until you can just see the jelly like coating appear on the top


THREE: Rotate the handle 4 clicks and apply Sure Seal hydrophobic coating to the lens by blotting contents of tube once on front surface. Rotate the handle 4 more clicks and place a blot on the back surface. NOTE: Each application of Sure Seal will require 4 clicks of the handle.


FOUR: Carefully polish the jelly like coating over the entire surface of the lens with a Kimwipe or similar lens tissue until a uniform haze has developed over both the front and back surface. Be sure to recap the Sure Seal tube after use.


FIVE: Place Sure Seal coated lenses in Post Cure annealing oven for 10 minutes.


SIX: Upon completion of the 10 minute annealing cycle, wash the pair of lenses with Q-Soak and an AR cloth under hot running water to remove the excess buffed coating.


SEVEN: Clean lenses with Q-Spray


Note: if at any time you observe your hydrophobic coating to become discolored from its original condition, it should be properly disposed of according to state and local regulations. A new tube should be used at this point. Failure to do so will result in a less than quality product.